how to open ati catalyst control center windows 7 32 bit

# sudo dpkg-reconfigure -phigh xserver-xorg # If you have edited this file but would like it to be automatically updated

# if it has not been modified since the last upgrade of the xserver-xorg # This file is automatically updated on xserver-xorg package upgrades *only* # Edit this file with caution, and see the nf(5) manual page. # This file was generated by dexconf, the Debian X Configuration tool, using # /etc/X11/nf (xorg X Window System server configuration file) I can move the mouse from one monitor to the other, but I cannot move windows/applications the way I can in Windoze. It seems as if each monitor is completely separate. However, it's not accelerated, the drivers don't seem to be used and big_desktop works strangely. I was even able to set up some sort of big_desktop. 40 drivers, and CCC works fine on my system. Any help you kind folks can offer will be greatly appreciated.ĭisplay:22' Viewsonic Flat panel LCD vx2245wm () below i will list my system specs, and an example of my nf file (at least the pertinent parts). After the reboot to use fglrx over vesa my system hangs when attempting to load X (at least i think that is where its hanging, going back into my nf file i can change the device back to vesa and load just fine) I am unable to swap 'desktops' ctrl+alt+f1 through f7 don't respond and numlock doesn't toggle (oldschool hardware lock test heh) I had to throw the acpi=off and pnpbios=off into my grub file to get Linux loaded at all (an overload of info is often better than a lack) at this point i am floundering attempting to get this card up and running. Following the instructions in 2 different wiki articles (clean install between both) and even trying envy as a last ditch effort (again after a clean install) I find myself with the same road block. Howdy folks, nice thread so far, it has been a great help.

How to open ati catalyst control center windows 7 32 bit